Kia Sorento: Front Impact Sensor (FIS) Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Installation

â€¢	Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.

1.	Install the new front impact sensor.

Tighten the front impact sensor mounting bolt.

Tightening torque

: 6.8 ~ 9.2 Nm (0.7 ~ 0.9 kgf.m, 5.0 ~ 6.8 lb.ft)

3.	Connect the front impact sensor connector.

4.	Reconnect the battery negative cable.

After installing the front impact sensor, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS) Removal

â€¢ Removal of the airbag must be performed according to the precautions/ procedures des ...

Side Impact Sensor (SIS) Description

Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

Kia Sorento: Front Impact Sensor (FIS) Installation

Front Impact Sensor (FIS) Removal

Side Impact Sensor (SIS) Description

See also:

Categories