Kia Sorento: TPMS Sensor Removal - Tire Pressure Monitoring System - Suspension System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: TPMS Sensor Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor Removal

Tire Removal
1.
Deflate tire & remove balance weights.
  
The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep.
Avoid tire/tool contact with the valve on dismount.
Dismount should end near the valve.

Sensor Removal
  
Handle the sensor with care.
1.
Remove the valve nut.

  
The valve nut should not be re-used.
2.
Discard the valve assembly.
TPMS Sensor Description
1. Mode (1) Configuration State A. All sensors should be in the Low Line state. ...

TPMS Sensor Installation
Sensor Fit    • Handle the sensor with care. • ...

See also:

Speakers Installation
Front speaker 1. Install the speaker to the speaker mounting hole in the door in-panel. 2. Reconnect the speaker connector. Rea ...

Master Cylinder Components
1. Reservoir cap 2. Reservoir 3. Grommet 4. Master cylinder ...

Knock Sensor (KS)
Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. Whe ...

Copyright www.ksmanual.com 2014-2026