Kia Sorento: Pressure Sensor Description - Coupling Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Pressure Sensor Description

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Pressure Sensor Description

The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque value varies according to a pressure status.

Oil hydraulic Motor(Actuator) Installation
1. Before installation, wipe the surface with a clean cloth. 2. Check the O-rings (A) of the new hydraulic motor (actuators). ...

Pressure Sensor Circuit Diagram
...

See also:

Component Location
1. Fuel filler door open switch 2. Fuel filler door release actuator ...

Mode Control Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the driver's side crash pad side cover. ...

Seat Heater Installation
1. Install the driver / assist seat heater. (Refer to Body - "Front seat") 2. Install the rear seat LH heater and RH heater. ...

Copyright www.ksmanual.com 2014-2026