Kia Sorento: 4WD ECU Circuit Diagram and Connector
Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / 4 Wheel Drive (4WD) System / 4WD Control System / 4WD ECU Circuit Diagram and Connector
| 4WD ECU Connector |
| Pin |
Function |
| 1 |
MOTOR A |
| 2 |
MOTOR B |
| 3 |
LOCK MODE SWITCH (Input) |
| 4 |
- |
| 5 |
PRESSURE SENSOR SIGNAL (Input) |
| 6 |
- |
| 7 |
CAN communication line (Low) |
| 8 |
CAN communication line (High) |
| 9 |
- |
| 10 |
- |
| 11 |
- |
| 12 |
IG. POWER (Input) |
| 13 |
GROUND |
| 14 |
BATTERY (Input) |
| 15 |
PRESSURE SENSOR GROUND (-) |
| 16 |
PRESSURE SENSOR SUPPLY (+) |
| 17 |
- |
| 18 |
- |
See also:
Engine start/stop button
Illuminated Engine Start/Stop button
Whenever the front door is opened, the ENGINE START/STOP button will illuminate
for your convenience.
The light will go off after about 30 seconds when the do ...
Timing Chain Cover Installation
1.
Install the timing chain cover.
(1)
Using a gasket scraper, remove all the old packing material
from the gasket surfaces.
...
Limp Home Function
1.
Limp Home By Tester
If the PCM(ECM) detects the fault of the SMARTRA or transponder,
the PCM(ECM) will allow limp home function of the immobilizer. Limp
hom ...
Copyright В© www.ksmanual.com 2014-2024