Kia Optima Manuals

Kia Sorento: Oil Seal Replacement - Transfer Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Oil Seal Replacement

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Oil Seal Replacement

[Right side]
1.
Remove the front muffler. (Only gasoline 3.3)
(Refer to Engine Mechanical System - "Front Muffler ")
2.
Remove the driveshaft assembly. (RH side)
(Refer to Driveshaft and axle - "Front Driveshaft ")
3.
Remove the dust cover (A).
4.
Remove the oil seal (A, B).
5.
Install the oil seal with special service tools.
  
•
Apply lithium type grease between seal lips.
•
Use the oil seal installer (09473-3B100) after removing the coupling (A).

6.
Install the new dust cover (A).
7.
Add to transfer fluid.
(Refer to 4 Wheel Drive System - "Transfer Fluid")
8.
Install the drive shaft assembly. (RH side)
(Refer to Driveshaft and axle - "Front Driveshaft ")
9.
Install the front muffler. (Only gasoline 3.3)
(Refer to Engine Mechanical System - "Front Muffler ")
[Left side]
1.
Remove the transfer assembly from the transaxle assembly.
(Refer to Transfer Assembyl - "Front Wheel Transfer Assembly")
2.
Remove the oil seal (A).
[Gasoline 2.4]

[Gasoline 3.3]
3.
Install the oil seal with special service tools.
  
•
Apply lithium type grease between seal lips.
•
Use the oil seal installer (09473-3B100) after removing the coupling (A).
(Gasoline 2.4)
•
Use the oil seal installer (09473-3B100) after installing the coupling (A).
(Gasoline 3.3)

[Gasoline 2.4]

[Gasoline 3.3]
4.
Add to transfer fluid.
(Refer to 4 Wheel Drive System - "Transfer Fluid")
5.
Install the transfer assembly.
(Refer to 4 Wheel Drive System - "Front Wheel Transfer Assembly")
Front Wheel Transfer Assembly Installation
1. Install in the reverse order of removal.    1. ...

4WD Control System
...

See also:

Description
The 6-speed automatic transaxle consists of an overdrive clutch (OD/C), a one-way clutch (OWC), a lower and reverse brake (LR/B), an underdrive brake (UD/B), a 26 brake (26/B), and a 35R clut ...

Antenna Removal
1. Remove the rear roof trim. (Refer to Body - "Roof trim") 2. Disconnect the power cable (A). 3. ...

Installation
1. Install the horns after connecting the horn connectors. 2. Install the head lamp. (Refer to "Lighting system") ...

Categories

Copyright www.ksmanual.com 2014-2026