Kia Sorento: Shift Cable Removal
| 1. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 2. |
Remove the air duct.
|
| 3. |
Disconnect the shift cable (A).
|
| 4. |
Remove the retainer (A) and nut (B).
|
| 5. |
Remove the nut (C) from the manual control lever.
|
| 6. |
Remove the cable (B) from the bracket (A) at transaxle assembly
side.
|
| 7. |
Remove the shift cable by pulling it toward the interior.
|
Shift Cable Components
1. Shift lever mounting bolt
2. Shift lever assembly
3. Shift cable assembly
4. Shift lever knob & boots assembly
5. Manual control lever
6. Retainer
...
Shift Cable Installation
1.
Install in the reverse order of removal.
Set shift lever and inhibitor ...
See also:
Blower Resistor Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below and if abnormal symp ...
Circuit Diagram
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026