Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Lift the vehicle.
|
| 3. |
Disconnect the canister close valve connector (A).
|
| 4. |
Disconnect the ventilation tube quick-connector (B) from the fuel
tank air filter and canister close valve.
|
| 5. |
Disconnect the vapor tube quick-connector (A).
|
| 6. |
Remove the canister assembly bracket (D) after removing the mounting
bolts (B) and nut (C).
|
| 7. |
Remove the canister braket (B) installation bolt (A).
|
| 8. |
Remove the fuel tank air filter & canister close valve assembly
(A) after rotating it in the direction of the arrow in the figure.
|
| 9. |
Release the lever (A), and then separate the canister close valve
(B) from the fuel tank air filter (C) after rotating it in the direction
of the arrow in the figure.
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the CCV connector.
3.
Measure resistance between the CCV termina ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Nut :
7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft)
...
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a know ...
Using the USB device
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connected ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026