Kia Sorento: Installation
| •
|
Do not reuse the used injector fixing clip.
|
|
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply engine oil to the injector O-ring.
|
| •
|
Do not reuse the used injector O-ring.
|
|
| •
|
Do not reuse the used bolt.
|
|
| •
|
When inserting the injector, be careful not to damage
the injector tip.
|
|
| •
|
Do not reuse the support disc.
|
| •
|
Do not reuse the injector rubber washer.
|
| •
|
When replacing the rubber washer, the steal plate (A)
part should be faced the cylinder installation part and the
rubber plate (B) part should be faced the injector body part.
|
|
| •
|
Do not reuse the combustion seal.
|
|
| •
|
When tightening the delivery pipe installation bolts,
tighten them in accordance with the order (
→  →  ) after
tightening with hand-screwed torque.
|
|
|
1. |
Install in the reverse order of removal.
|
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
See also:
Special Service Tools
Tools
(Number and name)
Illustration
Use
09431-45100
Oil seal installer
Installation of transfer case oil seal.
(Right side)
...
Spark Plug Description
A spark plug is a device for delivering electric current from an ignition
system to the combustion chamber of a spark-ignition engine to ignite the compressed
fuel/air mixture therein by mean ...
Refrigerant Recovery
Use only service equipment that is U.L-listed and is certified to meet
the requirements of SAE J2210 to remove HFC-134a(R-134a) from the air conditioning
system.
...
Removal
Replacement