Kia Optima Manuals

Kia Sorento: Removal - Injector - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Injector / Removal

  
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Engine Mechanical System - "Coolant")
  
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the delivery pipe & injector assembly.
(Refer to Fuel Delivery System - "Delivery Pipe")
4.
Remove the fixing clip (A), and then separate the injector from the delivery pipe.
Inspection
1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance between the inject ...

Installation
1. Combustion seal 2. Rubber washer 3. Support disc 4. O-ring ...

See also:

Towing service
If emergency towing is necessary, we recommend having it done by an authorized Kia dealer or a commercial tow-truck service. Proper lifting and towing procedures are necessary to prevent damage to ...

Circuit Diagram
Circuit Diagram (2) Circuit Diagram (3) ...

Antenna Coil Installation
1. Install the coil antenna and connect the 6P connector. 2. Install the steering column upper and lower shrouds. ...

Categories

Copyright www.ksmanual.com 2014-2026