Kia Sorento: Rail Pressure Sensor (RPS)

Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor converts the pressure to voltage signal. By using this signal, the ECM can control correct injection amount and timing and adjusts the fuel pressure with the fuel pressure regulator valve if the target pressure and the actual pressure calculated by the RPS output signal are different.

Installation

   • Install the component with the specified torques. • ...

Specification

...

See also:

Refrigerant Line Replacement
1. Discharge refrigerant from refrigeration system. 2. Replace faulty tube or hose.    ...

Brake Line Removal
1. Disconnect the brake fiuid level switch connector, and remove the reservoir cap. 2. Remove the brake fluid from the master cylinder rese ...

Rear Hub - Carrier Components
1. Rear carrier assembly 2. Parking brake assembly 3. Rear hub assembly 4. Rear brake disc ...