Kia Sorento: Removal - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line")
  
When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of “Release Residual Pressure in Fuel Line” work.
3.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
4.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
   • Install the component with the specified torques. • ...

See also:

Alternator Installation
1. Install in the reverse order of removal. 2. Adjust the alternator belt tension after installation. (Refer to Engine Mechanical ...

Coolant Refilling And Bleeding
   Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure ...

Hands Free Switch Removal
1. Remove the driver airbag module. (Refer to Restraint - "Airbag module") 2. Remove the steering wheel front cover (A) after ...

Copyright www.ksmanual.com 2014-2026