Kia Sorento: Inspection - Rail Pressure Sensor (RPS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Inspection

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Control / Fuel System / Engine Control System / Rail Pressure Sensor (RPS) / Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
Condition
Output Voltage (V)
Idle
 Approx. 1.2
1,500 rpm
 2.0 ~ 2.2
6,300 rpm
 Approx. 2.8

Circuit Diagram
...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refe ...

See also:

Fuel Tank Removal
1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") ...

Seat Heater Component Location
...

Yaw-rate and G Sensor Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

Copyright © www.ksmanual.com 2014-2019