Kia Sorento: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
Manifold absolute pressure sensor
installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...
See also:
Antenna Removal
1.
Remove the rear roof trim.
(Refer to Body - "Roof trim")
2.
Disconnect the power cable (A).
3. ...
Cylinder Head Installation
•
Thoroughly clean all parts to be assembled.
•
...
IPM Installation
1.
Install IPM(Intelligent intergrated Platform Module).
2.
Connect the IPM connector.
3.
Install the crash pad ...
Removal
