Kia Sorento: Engine Control Module (ECM) Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Control Module (ECM) Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the ECM Connector (A).
|
| 3. |
Remove the battery.
(Refer to Engine Electrical System - "Battery")
|
| 4. |
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 5. |
Remove the mounting bolt (A) and nuts (B), and then remove the
ECM (C).
|
| 6. |
After romoving the installation nuts (A) and screws (B), romove
the ECM (C) from the bracket.
|
Engine Control Module (ECM) Installation
1.
Install in the reverse order of removal.
ECM installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,7.2 ~ 8.7 lb-ft)
ECM ...
See also:
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM)
or when providing additional keys to the vehicle owner.
The procedu ...
Front Bumper Replacement
•
Pry the trim off using a plastic trim tool and apply protective
tape around the rela ...
Front Wiper Motor Removal
1.
Remove the windshield wiper arm and blade after removing a nut
(B) and wiper cap (A).
2.
Remove the windshield wiper arm and bla ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026