Kia Sorento: Lane Departure Warning System (LDWS) Unit Removal - Lane Departure Warning System (LDWS) - Body Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Lane Departure Warning System (LDWS) Unit Removal

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Body Electrical System / Lane Departure Warning System (LDWS) / Lane Departure Warning System (LDWS) Unit Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the LDWS unit cover (A).

3.
Remove the LDWS unit connector (A).

4.
Remove the LDWS unit (A) after widening the mounting clips.

  
Be careful not to warp the coupler (B) when removing the LDWS unit (A).

Lane Departure Warning System (LDWS) Unit Components
...

Lane Departure Warning System (LDWS) Unit Installation
1. Install the LDWS unit. 2. Install the LDWS unit cover. 3. Check LDWS system operation. ...

See also:

Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver and pass ...

Antenna Removal
1. Remove the rear roof trim. (Refer to Body - "Roof trim") 2. Disconnect the power cable (A). 3. ...

IMS Power Seat Control Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the power seat control switch connectors (A). (Refer to Body - "Front se ...

Copyright © www.ksmanual.com 2014-2019