Kia Sorento: Starter Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the air duct and air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
|
| 3. |
Remove the ETC module.
(Refer to Fuel System - "ETC")
|
| 4. |
Remove the intake manifold stay (A).
|
| 5. |
Disconnect the starter cable (A) from the B terminal on the solenoid,
then disconnect the connector (B) from the S terminal.
|
| 6. |
Remove the 2 bolts (C) holding the starter, then remove the starter.
|
| 7. |
Remove the 2 bolts holding the starter, then remove the starter
(A).
|
Starter Installation
1.
Install in the reverse order of removal.
Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
...
See also:
Adjustment
Transaxle Control Module(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learni ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Front Strut Assembly Removel
1.
Remove the front wheel and tire (A) from front hub .
Tightening torque:
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026