Kia Sorento: Starter Installation - Starting System - Engine Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Starter Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Electrical System / Starting System / Starter Installation

1.
Install in the reverse order of removal.

Starter installation bolt:
49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Starter Removal
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

Starter Disassembly
1. Disconnect the M-terminal (A) on the magnet switch assembly (B). 2. After loosening the screws (A), detach the magnet switch assembly ...

See also:

Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. ➀ BSD ...

Description
Limitations Of The Navigation system GPS Signal Reception State As the GPS satellite frequency is received/transmitted in straight lines, reception may not work if hiding devices are pla ...

Input Speed Sensor Installation
1. Install in the reverse order of removal.    • ...

Copyright © www.ksmanual.com 2014-2019