Kia Sorento: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
| 3. |
Disconnect the solenoid valve connector (A).
|
| 4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 5. |
Check that the resistance is within the specification.
|
Circuit Diagram
RemovalAC Inverter Switch Removal
•
Pry the trim off using a plastic trim tool and apply protective
tape around the rela ...
Interior D
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Front pillar ...
Idler Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the idler(A).
Tightenin ...