Kia Sorento: Compressor Oil Specification
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Air conditioning System / Compressor Oil Specification
| 1. |
The HFC-134a system requires synthetic (PAG) compressor oil whereas
the R-12 system requires mineral compressor oil. The two oils must never
be mixed.
|
| 2. |
Compressor (PAG) oil varies according to compressor model. Be
sure to use oil specified for the model of compressor.
|
Handling of Oil
| 1. |
The oil should be free from moisture, dust, metal powder, etc.
|
| 2. |
Do not mix with other oil.
|
| 3. |
The water content in the oil increases when exposed to air. After
use, seal oil from air immediately. (HFC-134a Compressor Oil absorbs
moisture very easily.)
|
| 4. |
The compressor oil must be stored in steel containers, not in
plastic containers.
|
Compressor Oil Check
The oil used to lubricate the compressor circulates with the refrigerant.
Whenever replacing any component of the system or a large amount of gas
leakage occurs, add oil to maintain the original amount of oil.
Oil total volume in system
Front only : PAG 120 ± 10cc (4.1±0.3oz.)
Front & Rear : PAG 180 ± 10cc (6.1±0.3oz.)
|
Oil Return Operation
There is close affinity between the oil and refrigerant.
During normal operation, part of the oil recirculates with the refrigerant
in the system. When checking the amount of oil in the system, or replacing any
component of the system, the compressor must run in advance for oil return operation.
The procedure is as follows:
| 1. |
Open all the doors and engine hood.
|
| 2. |
Start the engine and air conditioning switch to "ON" and set the
blower motor control knob at its highest position.
|
| 3. |
Run the compressor for more than 20 minutes between 800 and 1,000
rpm in order to operate the system.
|
| 4. |
Stop the engine.
|
Component Location
[Engine Room]
1. Receiver-drier
2. Condenser
3. Ambient temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Servic ...
Refrigerant Line Replacement
1.
Discharge refrigerant from refrigeration system.
2.
Replace faulty tube or hose.
...
See also:
Emergency starting
Connect cables in numerical order and disconnect in reverse order.
Jump starting
Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm
to yourself or damage to your vehicle ...
License Lamps Installation
1.
Install the bulb.
2.
Install the license lamp lens.
...
Specifications
Items
Specifications
Rated voltage
5V
Load
Max. 1mA
Detection illuminations
Tail lamp
ON : 2.7 ± 0.05 (V)
OFF : 4.3 ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026