Kia Sorento: Description - Back View Camera System - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Description

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Back View Camera System / Description

Back view camera will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.
This system is a supplemental system that shows behind the vehicle through the AVN or Audio head unit while backing-up.
  
This system is a supplementary function only. It is the responsibility of the driver or always check the inside/ outside rearview mirror and the area behind the vehicle before and while backing up because there is a dead zone that can't see through the camera.
Circuit Diagram
...

Removal
1. Remove the tailgate trim in the trunk after removing the screws and clips. (Refer to Body - "Tailgate") 2. Remove the ...

See also:

Erasing programmed HomeLink buttons
To erase the three programmed buttons (individual buttons cannot be erased): Press and hold the left and center buttons simultaneously, until the indicator light begins to flash (approximately 20 ...

PTG Spindle Installation
1. Connect the PTG spindle, bracket and connector. Tightening torque : 6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0 lb-ft) ...

Compass Mirror Function
1. Push the A button lower of the rear view mirror to turn on the function of the compass mirror so that displays a sign of a direction on the small board in the upper ...

Copyright www.ksmanual.com 2014-2026