Kia Sorento: Immobilizer Control Unit Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the crash pad lower panel (A). (Refer to Body - "Crash pad")

3.	Disconnect the 5P connector of the SMARTRA unit and then remove the SMARTRA unit (A) after loosening a bolt.

Diagnosis Of Immobilizer Faults

- Communication between the ECM and the SMARTRA. - Function of the SMARTRA and the transponder. - Data (stored in the EC ...

Immobilizer Control Unit Installation

1. Install the immobilizer control unit after connecting the unit connector. 2. Install the crash pad lower panel. ...

See also:

Power outlet
The power outlet is designed to provide power for mobile telephones or other devices designed to operate with vehicle electrical systems. The devices should draw less than 10 amps with the engine ...

Flex Steering Circuit Diagram
...

Rear Driveshaft Reassembly
1. Wrap tape around the driveshaft splines (TJ side ) to prevent damage to the boots. 2. Apply grease to the driveshaft and install the boo ...

Categories

Copyright © www.ksmanual.com 2014-2026