Kia Sorento: Immobilizer Control Unit Installation - Immobilizer System - Body Electrical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Immobilizer Control Unit Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Installation

1.
Install the immobilizer control unit after connecting the unit connector.
2.
Install the crash pad lower panel.
Immobilizer Control Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash pad") ...

Antenna Coil Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds (A). 3. ...

See also:

Inside rearview mirror
Adjust the rearview mirror so that the center view through the rear window is seen. Make this adjustment before you start driving. WARNING - Rear visibility Do not place objects in the rear seat or ...

Compass Mirror Calibration Procedure
If the compass has been calibrated or set to variance zone number incorrectly, or you are driving in specific places (tunnel, parking lot in building, underground parking lot, near transforme ...

Transmitter Code Registration (Using GDS)
1. Connect the DLC cable of GDS to the data link connector (16 pins) in driver side crash pad lower panel, turn the power on GDS. 2. ...

Copyright © www.ksmanual.com 2014-2019