Kia Sorento: Rheostat Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Lighting System / Rheostat Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad side cover.
|
| 3. |
Remove the lower crash pad switch assembly (A) after loosening
the screws.
|
| 4. |
Remove the rheostat switch connector (A).
|
| 5. |
Remove the rheostat switch (A) from lower crash pad switch assembly.
|
| 6. |
Check for intensity of new rheostat switch. If the light intensity
of the lamps changes smoothly without any flickering when the rheostat
is turned, it can be assumed that the rheostat is normal.
|
Hazard Lamp Switch Inspection
Diagnosis With GDS
1.
It will be able to diagnose defects of IPM with GDS quickly. GDS
can operates actuator forcefully, input/output value monitoring and
self dia ...
Front Fog Lamps Inspection
1.
With the fog lamp switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the multifunctio ...
See also:
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
Front Impact Sensor (FIS) Description
The front impact sensor (FIS) is installed in the Front End Module (FEM).
They are remote sensors that detect acceleration due to a collision at its mounting
location. The primary purpose of ...
Spark Plug Installation
1.
Install in the reverse order of removal.
Tightening torque:
14.7 ~ 24.5 N.m (1.5 ~ 2.5 kgf.m, 10.8 ~ 18.0 Ib-ft)
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026