Kia Sorento: Overhead Console Lamp Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Lighting System / Overhead Console Lamp Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the mounting screws (2EA).
And then remove the overhead console (A).
|
| 3. |
Remove the overhead console lamp (B) from the head lining after
disconnecting the sunroof switch connector and map lamp switch connector
(A).
|
| 4. |
If the bulb only should be replaced, replace the bulb after removing
the lens.
|
Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.
...
Overhead Console Lamp Installation
1.
Install the overhead console lamp after connecting the sunroof
switch connector and lamp connector.
2.
Install the lens after tightening ...
See also:
Normal maintenance schedule
The following maintenance services must be performed to ensure good emission
control and performance.
Keep receipts for all vehicle emission services to protect your warranty. Where
both mileage an ...
Oil Pan Removal
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the A/C compressor.
(Refer to Heating, Ve ...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026