Kia Sorento: Power Seat Motor Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Seat Electrical / Power Seat Motor Inspection
Power Seat Motor
| 1. |
Disconnect the connectors for each motor.
(Refer to Body - "Front seat")
|
| 2. |
With the battery connected directly to the motor terminals, check
if the motors run smoothly.
|
| 3. |
Reverse the connections and check that the motor turns in reverse.
|
| 4. |
If there is an abnormality, replace the motors.
|
Component Location
1. Slide motor
2. Front height motor
3. Rear height motor
4. Lumber support motor
5. Power seat switch
6. Reclining motor
7. Reclining switch
8. Lumber support swit ...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
See also:
Troubleshooting
Symptom
Possible cause
Remedy
Speedometer does not operate
Cluster fuse (10A) blown
Check for short and replace fuse
Speedometer faulty
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Alternator Components
1. Overrun Alternator Pully (OAP)
2. Front bracket
3. Front bearing
4. Rotor
5. Rear bearing
6. Rear bracket
7. Through bolt
8. Regulator assembly
9. Regulator b ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026