Kia Sorento: Troubleshooting - Panorama Sunroof - Body (Interior and Exterior)Kia Sorento: Troubleshooting

Kia Sorento (MQ4, 2021-2026) Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Troubleshooting

Troubleshooting
Water leaks
Components
Suspected Cause
Correction
Movable Glass
Defect of gap/flush
Adjustment
Weatherstrip
Incorrect installation and deformation
Replacement

Wind noise
Components
Suspected Cause
Correction
Deflector
Deformation and separation
Replace or reinstall
Movable Glass
Defect of gap/flush
Adjust of gap/flush

Drive noise
Components
Suspected Cause
Correction
Weatherstrip
Rubbing noise
apply the silicone oil
Hardware
Loose or unfastened
Hardware re-tighten
Cover / Trims
Interference noise (rattle/rubbing)
Attach the pad to the noise generating area.

Operation noise
Components
Suspected Cause
Correction
Mechanism rail
Foreign matters in the mechanism rail
Cleaning the rail and apply the grease
Motor
Defective coupling of mechanism cable and motor pinion gear
Adjust or replace the motor position
Motor pinion gear worn out or broken
Replacement
Roller Blind
Noise inside the spring
Replacement

malfunctions
Components
Suspected Cause
Correction
Mechanism rail
Increased operating load due to accumulation of foreign matters
1. Cleaning the rail and apply the grease
2. Adjust or replace the motor position
3. Replacement of mechanism rail
Motor
Defective coupling of mechanism cable and motor pinion gear
Adjust or replace the motor position
Motor position loss and sunroof switch one-touch operation failure due to discharge and replacement of battery and fuse
Motor Initialization
Roller Blind
Separation of the teflon guide
Replace or reinstall
Release of the spring tension
Replacement

Components and Components Location
Component and Component Location Panorama Sunroof 1. Sunroof Side Molding2. Front glass3. Movable glass4. Rear glass5. Front ...
Adjustment
Adjustment Glass step alignment 1. Perform considerable step alignment after replacing movable glass (A). ...
See also:

Tightening Torque
Tightening Torque Automatic Transaxle Assembly Item N·m kgf·m ...

Blind Spot Detection Unit Installation
1. Install the BSD units to the rear bumper. 2. Install the rear bumper. 3. Connect the negative (-) battery te ...

ECM Terminal And Input/Output signal
ECM Terminal Function Connector [C300-A] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output [NON-smart ke ...

Copyright © www.ksmanual.com 2014-2026 - 0.0563