Kia Sorento: Adjustment - Panorama Sunroof - Body (Interior and Exterior)Kia Sorento: Adjustment

Kia Sorento (MQ4, 2021-2026) Service Manual / Body (Interior and Exterior) / Panorama Sunroof / Adjustment

Adjustment
Glass step alignment
1.
Perform considerable step alignment after replacing movable glass (A).

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration


2.
Remove the decoration cover (A).

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

3.
If it is necessary to adjust the glass (A), slightly loosen the glass height adjustment screws (B) and tighten the screws.

Tightening torque :
2.0 - 3.9 N·m (0.2 - 0.4 kgf·m, 1.4 - 2.9 lb·ft)

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

Initialize Sunroof
If necessary, initialize the sunroof according to the initialization method.
The sunroof and rear blind are initialized using the sunroof switch.
1.
IG ON or start the vehicle.
2.
Close the sunroof completely if opened
3.
Release the sunroof control lever.
4.
With the sunroof glass or rear sunshade fully closed, lightly press the switch until it activates once, then immediately release the switch.
5.
Press and hold the sunroof switch in the forward (close) direction until the sunroof glass or rear sunshade completes a full open-and-close cycle.
Note
•
Do not release the switch until the operation is complete.
•
If the switch is released before completion, the initialization process must be restarted from the beginning.
6.
Release the sunroof control lever after all operation has completed.
(The sunroof system been reset.)
When to perform motor initialization
1.
The first operation during vehicle production.
2.
The initial value has been erased or damaged by interruption of power supply or discharge while operation.
3.
After operating with the emergency hex crew on motor.
4.
When replacing the battery or the fuse.
5.
After replacing the motor and repairing the sunroof.
Emergency Operation
1.
The emergency operation of the panoramic sunroof should never be done unless the motor is not working properly.
2.
After removing the roof trim, use a hexagon wrench to close or open the panoramic sunroof and do not apply excessive force.
[Roller blind motor]

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

[Movable glass motor]

Body (Interior and Exterior) — Panorama Sunroof / Adjustment illustration

3.
In case of emergency operation of the sunroof, initialize the sunroof for normal sunroof operation.
Troubleshooting
Troubleshooting Water leaks Components Suspected Cause Correction Movable Glass ...
Movable Glass Repair Procedures
Removal 1. Press the sunroof switch to tilt the sunroof glass. 2. Remove the front decoration co...
See also:

Cluster Removal and Installation
Removal ...

Head Lamps Component (2)
1. Head lamp assembly 2. Head lamp high beam bulb 3. Head lamp low beam bulb (HID & ignitor) 4. Dust cap 5. Turn signal lamp socket & bulb ...

Radiator Components
1. Radiator 2. Radiator lower hose 3. Radiator upper hose 4. Radiator upper air guard 5. Radiator upper mounting bracket 6. Radiator lower mounting insulator ...

Copyright © www.ksmanual.com 2014-2026 - 0.0632