Kia Sorento: Tire (pressure & tread wear) Repair procedures - Chassis - MaintenanceKia Sorento: Tire (pressure & tread wear) Repair procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Maintenance / Chassis / Tire (pressure & tread wear) Repair procedures

Inspection
1.
Check the tire pressure.
Tire Size
Tire Pressure [kPa (psi)]
235/65 R17
240 (35)
235/60 R18
255/45 R20

Tire Rotation
Note
Changing directional or asymmetric tires left/right and diagonally may result in poor driving and braking performance.
Replace the tire in the direction shown by the arrow in the figure below.

Maintenance — Chassis / Tire (pressure & tread wear) / Repair procedures / Inspection illustration

Rotating For Pull And Wander
If the vehicle is pulled to one side without any particular symptoms of failure, tire wear may be the cause.
In this case, the following tire replacement procedures shall be performed.
1.
Rotate the front right and front left tires, and perform a road test in order to confirm vehicle stability.

Maintenance — Chassis / Tire (pressure & tread wear) / Repair procedures / Inspection illustration

2.
If the steering pulls to the opposite side, rotate the front and rear tires, and perform a road test again.

Maintenance — Chassis / Tire (pressure & tread wear) / Repair procedures / Inspection illustration

3.
If the steering continues to pull to one side, rotate the front right and left tires again, and perform a road test.

Maintenance — Chassis / Tire (pressure & tread wear) / Repair procedures / Inspection illustration

4.
If the steering continues to pull to the opposite side, replace the front wheels with new ones.

Maintenance — Chassis / Tire (pressure & tread wear) / Repair procedures / Inspection illustration

Tire Wear
Caution
•
Using tires and wheel other than the recommended sizes could cause unusual handling characteristics and poor vehicle control, resulting in a serious accident.
1.
Measure the tread depth of the tires.

Tread depth [limit] : 1.6 mm (0.0630 in.)

2.
If the remaining tread depth (A) is less than the limit, replace the tire.
Note
When the tread depth of the tires is less than 1.6 mm(0.0630 in), the wear indicators (B) will appear.

Maintenance — Chassis / Tire (pressure & tread wear) / Repair procedures / Inspection illustration

Suspension Ball Joints Repair procedures. Suspension Mounting Bolts Repair procedures
Suspension Ball Joints Repair procedures Inspection Visually check, must be free from injurious flaw and crack. Suspension Mounting Bolts Repair procedures ...
Body
...
See also:

Driver Airbag (DAB) Removal and Installation
Removal 1. Disconnect the battery negative ( - ) terminal. ...

Rear Cross Member Repair procedures
Removal 1. Disconnect the (-) battery terminal. 2. Remove the rear wheel and t ...

Component Location
1. Back view camera 2. AVN/Audio head unit ...

Copyright © www.ksmanual.com 2014-2026 - 0.0659