Kia Optima Manuals

Kia Sorento: Driver Airbag (DAB) Removal and Installation - Airbag Module - RestraintKia Sorento: Driver Airbag (DAB) Removal and Installation

Kia Sorento (MQ4, 2021-2026) Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Removal and Installation

Removal
1.
Disconnect the battery negative ( - ) terminal.
Note
After disconnecting the battery negative ( - ) terminal, wait at least 3 minutes and 30 seconds.
2.
Remove the driver airbag by pressing the driver airbag lock levers (B) using the service hole (A).

Restraint — Airbag Module / Driver Airbag (DAB) / Removal and Installation / Removal illustration

Restraint — Airbag Module / Driver Airbag (DAB) / Removal and Installation / Removal illustration

Restraint — Airbag Module / Driver Airbag (DAB) / Removal and Installation / Removal illustration

How to Release the Lock Levers When Removing the DAB Module and How to Install It (Play ▶)Restraint — Airbag Module / Driver Airbag (DAB) / Removal and Installation / Removal illustration
Notes When Refering Video
This video helps clearly identify areas that are hard to distinguish in manual images, such as component locations or assembly structures.
It also allows visual confirmation of areas that are difficult to see directly due to restricted visibility caused by surrounding components, from a technician’s perspective.
•
This video is created using common specifications and may differ from the actual vehicle.
•
The location and repair procedures of the parts may vary depending on vehicle model, model year, region, and specifications.
•
Check the KDS Guide for detailed information on how to use the KDS.
•
Check the manual for detailed maintenance procedures.
•
Unauthorized reproduction, distribution, or sharing of this video is prohibited.
3.
Remove the driver airbag (A).

Restraint — Airbag Module / Driver Airbag (DAB) / Removal and Installation / Removal illustration
4.
Disconnect the driver airbag connectors (A) and horn connector (B).

Restraint — Airbag Module / Driver Airbag (DAB) / Removal and Installation / Removal illustration
Installation
1.
Install in the reverse order of removal.
Note
•
When assembling the driver airbag to the wheel, make sure that the airbag wire is not caught in the wheel's internal structure.
•
Assemble the airbag wire while pressing it toward the center of the driver airbag
2.
Check the airbag system and horn operate normally.
Note
When the IG is on, the airbag warning lamp should turns off after turning on for 3 - 6 seconds.
Driver Airbag (DAB) On Vehicle Inspection. Driver Airbag (DAB) Troubleshooting
Driver Airbag (DAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The driver airba...
Side Airbag (SAB) On Vehicle Inspection. Side Airbag (SAB) Troubleshooting
Side Airbag (SAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The side airbag ca...
See also:

Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

Battery replacement
A smart key battery should last for several years, but if the smart key is not working properly, try replacing the battery with a new one. If you are unsure how to use your smart key or replace th ...

AC Inverter Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the right luggage side trim. (Refer to Body - "Luggage Side Trim") ...

Manuals list

Copyright © www.ksmanual.com 2014-2026 - 0.0636