Kia Optima Manuals

Kia Sorento: Starter Relay Inspection - Starting System - Engine Electrical SystemKia Sorento: Starter Relay Inspection

Kia Sorento (MQ4, 2021-2026) Service Manual / Engine Electrical System / Starting System / Starter Relay Inspection

Inspection
1.
Disconnect the battery negative ( - ) terminal.
2.
Remove the fuse box cover in the engine room.
3.
Remove the starter relay (A).

Engine Electrical System — Starting System / Starter Relay / Inspection illustration
4.
Check for continuity between the terminals (30 and 87) using an ohmmeter.
Terminal
 Resistance
 Measure
30 - 87
 1MΩ or above
 If there is continuity between the terminals, replace the relay.

Engine Electrical System — Starting System / Starter Relay / Inspection illustration
5.
Apply 12 V to the terminal 85 and ground to the terminal 86 and then check for continuity between the terminals (30 and 87).
Terminal
 Resistance
 Measure
30 - 87
 1Ω or below (About 0 Ω)
 If there is no continuity between the terminals, replace the relay.

Engine Electrical System — Starting System / Starter Relay / Inspection illustration
6.
Install the starter relay.
7.
Install the fuse box cover.
Starter Cleaning
Cleaning 1. Do not immerse parts in cleaning solvent. Immersing the yoke assembly and/or armature will damage the insulation wipe these parts w...
Emission Control System
...
See also:

Description
Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an ...

Crash Pad Center Panel Repair Procedures
Removal 1. Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly") ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Manuals list

Copyright © www.ksmanual.com 2014-2026 - 0.0498