Kia Sorento: Special Service Tools - Driveshaft and axle - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Special Service Tools

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Driveshaft and axle / Special Service Tools

Tool(Number and Name)
Illustration
Use
09495-3K000
Band installer

Installation of ear type boot band
09568-4A000
Ball joint puller

Remove the ball joint
09495-33000
Puller

Removal of spider assembly from a drive shaft.
09530-2W100
Differential side oil seal installer

Installation of the differential side oil seal.
(Use with 09231-H1100)
09530-2W200
Removing plate

Removal of the pinion drive inner bearing.
09530-2W300
Pinion drive shaft lock holder

Pinion drive shaft lock nut.
09530-2W400
Pinion drive shaft lock installer

Pinion height measuring gauge.
09530-2W600
Pinion height gauge
(3 piece set)

Pinion height measuring gauge.
09530-2W700
Pinion oil seal installer

Installation of the pinion oil seal installer.
(Use with 09231-H1100)
09527-4A000
Removing plate

Removal of the differential carrier assembly inner bearing.
09532-11500A
Bearing outer race installer

Installation of the bearing outer race.
(Use with 09500-11000)
09453-02100
Bearing installer

Installation of the differential carrier assembly inner bearing.
09431-26200
Pinion drive outer bearing race installer

Installation of the pinion drive outer bearing race.
(Use with 09231-H1100)
09530-3T300
Differential assembly warking stand

Removal & Installation of the differential assembly warking stand.
09231-H1100
Bar

Use with 9530-2W100, 09530-2W700, 09431-26200.
09500-11000
Bar

Use with 9532-11500A.

Lubricants
Items Lubricants Quantity (g) Front driveshaft LSJ 104 SH06-VX21 240 ~ 255 UBJ 104 RBA 165 ~ 175 LSJ 100 ...

Troubleshooting
Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

See also:

ECM Problem Inspection Procedure
1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

SS-A Solenoid Valve(ON/OFF)
SS-A solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed at valve body. ...

Description
System Operation Typically, lane departure warning is activated at a speed over 60 km, but suppressed in case of unintentional lane departure when driver do not operate turn signal. S ...

Copyright В© www.ksmanual.com 2014-2023