Kia Sorento: Auto Head lamp leveling Unit Removal - Head lamp leveling Device - Body Electrical System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Auto Head lamp leveling Unit Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Head lamp leveling Device / Auto Head lamp leveling Unit Removal

Height Sensor & Unit
1.
Disconnect the negative(-) battery terminal.
2.
Remove the height sensor connector (A).

3.
Loosen the mounting bolts (2EA) from height sensor bracket after removing the linkage (A).

Torque :
3 ~ 5 N.m (0.3 ~ 0.5 kgf.m, 2.21 ~ 3.68 lbf-ft)

4.
Remove the height sensor.
Auto Head lamp leveling Unit Operation
Operating Procedure 1. Suspension angle change resulted from vehicle's load change. 2. Height sensor signal change ...

Auto Head lamp leveling Unit Installation
Height Sensor & Unit 1. Install the height sensor. 2. Connect the connector. ...

See also:

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be used ...

4WD ECU Installation
1. Install in the reverse order of removal. 2. Prior to installing a new ECU, upload the original ECU’s clutch learing to the replacement ...

IMS Control Switch Inspection
1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity ex ...

Copyright В© www.ksmanual.com 2014-2025