Kia Sorento: Seat Heater Switch Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Inspection
Front Seat Heater Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
|
| 3. |
Disconnect the connectors and cables (A) from center fascia panel.
|
| 4. |
Remove the driver and assist seat heater switch connector.
|
| 5. |
Check that continuity exists between the terminals after turning
the driver seat heater switch ON.
|
| 6. |
If the switch fails to operate, replace the driver and assist
seat heater switch (A).
|
2nd Seat Heater Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the floor console rear cover (A).
(Refer to Body - "Console")
|
| 3. |
Turn 2nd seat heater switch ON and check that continuity exists
between the terminals.
|
| 4. |
Replace the 2nd seat heater switch.
|
Power Seat Control Switch Installation
1.
Install the power seat control switch after connecting the connector.
...
See also:
Operation
Power Tailgate Opening
** - Primary switch signal received by PTGM via CAN bus (sent by IPM)
PTGM Opening procedure:
1.
Opening can be triggered after a signal i ...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Panorama Sunroof Adjustment
Inspect Glass Alignment
1.
Inspect the alignment of the movable glass (C) that is between
the front (A) and rear (B) glass and if needed adjust it.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026