1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
2. |
Remove the emergency fastening device cover pad (A). [Driver only]
|
3. |
Remove the seat belt after pushing the lock pin with a fiat-tip
screwdriver (B).
|
4. |
Remove the door scuff trim. (Refer to the Body group- Interior
trim)
|
5. |
Remove the center pillar trim. (Refer to the Body group- Interior
trim)
|
6. |
Remove the seat belt upper mounting bolt.
|
7. |
Loosen the seat belt pretensioner mounting bolt (A, B) and remove
the seat belt pretensioner.
|
8. |
Disconnect the seat belt pretensioner connector.
|
ICM Relay Box Inspection
Rear Wiper Motor relay
Check for continuity between the terminals.
1.
There should be continuity between the No.1 and No.3 terminals
when power and ground are conne ...
Removal
1.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
2.
Remove the battery and the battery tray.
...
OBD-II review
1. Overview
The California Air Resources Board (CARB) began regulation of On Board
Diagnostics (OBD) for vehicles sold in California beginning with the 1988 model
year. The first phase, O ...