Kia Sorento: Reservoir Tank Removal and Installation - Cooling System - Engine Mechanical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Reservoir Tank Removal and Installation

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Engine Mechanical System / Cooling System / Reservoir Tank Removal and Installation

1.
Remove the over flow hose(A).
2.
Remove the reservoir tank(B) after loosening the bolts.

Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

3.
Install in the reverse order of removal.
Cooling Fan Disassembly
1. Remove the cooling fan (A) after loosening the screws (B) from the cooling assembly. Tightening torque: 2.7 ~ 3.2 N.m (0.28 ~ 0.3 ...

Water Temperature Control Assembly Components
1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor 5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant ho ...

See also:

Cylinder Block Reassembly
1. Install the oil jet (A). Tightening torque : 24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft) ...

Blower Motor Inspection
1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a know ...

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Copyright В© www.ksmanual.com 2014-2023