Kia Optima Manuals

Kia Sorento: Repair Procedures - Multifunction Switch - Body Electrical SystemKia Sorento: Repair Procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Body Electrical System / Multifunction Switch / Repair Procedures

Removal
1.
Remove the steering column shroud panel.
(Refer to Body - "Steering Column Shroud Panel")
2.
Disconnect the multifunction switch connectors (A).

Body Electrical System — Multifunction Switch / Repair Procedures / Removal illustration
3.
Remove the multifunction switch assembly (A) after removing the bolt.
Tightening torque :
4.5 - 6.5 N·m (0.46 - 0.66 kgf·m, 3.3 - 4.8 lb·ft, 39.9 - 57.3 lb·in)

Body Electrical System — Multifunction Switch / Repair Procedures / Removal illustration
Installation
1.
Install in the reverse order of removal.
2.
Perform the order below with the KDS when replacing the multifunction switch.
(S/W Management → Brake → Steering Angle Sensor(SAS) Calibration)
Information
Refer to the KDS screen for operating conditions and details.
Inspection
Component Inspection
1.
Check for continuity between the terminals in each switch position as shown below.

Body Electrical System — Multifunction Switch / Repair Procedures / Inspection illustration

Switch
 Switch Function
 Pin No.
Resistance (Ω, ±3.5%)
Light switch
 OFF
 10 - 4
 680
AUTO
 1,680
Tail Lamp
 5,580
Low beam
 ∞
Dimmer and Passing switch
 OFF
 13 - 4
 ∞
Passing
 910
Dimmer
 2,910
Turn signal switch (Left)
 OFF
 14 - 4
 ∞
1 level
 910
2 level
 2,910
Turn signal switch (Right)
 OFF
 15 - 4
 ∞
1 level
 910
2 level
 2,910
Fog lamp switch
 OFF
 12 - 4
 ∞
Front
 910
Rear
 2,910
Front wiper switch
 MIST
 6 - 4
 330
OFF
 ∞
INT (AUTO)
 800
Low
 1,800
High
 5,700
Wiper intermittent volume
 Volume 1
 3 - 4
 330
Volume 2
 690
Volume 3
 1,310
Volume 4
 2,610
Volume 5
 7,310
Rear wiper switch
 OFF
 11 - 4
 ∞
Low
 910
High
 2,910

On Vehicle Inspection
On Vehicle Inspection Diagnostic with KDS 1. The multifunction switch can quickly diagnosed for problems with the KDS. (R...
Over The Air (OTA)
...
See also:

Jack and tools. Jacking instructions. Removing and storing the spare tire
Jack and tools. Jacking instructions ...

Trailing Arm Replacement
1. Remove the rear wheel & tire. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

ESC OFF Switch Description
1. The ESC OFF switch is for the user to turn off the ESC system. 2. The ESC OFF lamp is on when ESC OFF switch is engaged. ...

Manuals list

Copyright © www.ksmanual.com 2014-2026 - 0.0582