Kia Sorento: Removal - Canister Close Valve (CCV) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Engine Control / Fuel System / Engine Control System / Canister Close Valve (CCV) / Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Lift the vehicle.
3.
Disconnect the canister close valve connector (A).
4.
Disconnect the ventilation tube quick-connector (B) from the fuel tank air filter and canister close valve.

5.
Disconnect the vapor tube quick-connector (A).
6.
Remove the canister assembly bracket (D) after removing the mounting bolts (B) and nut (C).

7.
Remove the canister braket (B) installation bolt (A).

8.
Remove the fuel tank air filter & canister close valve assembly (A) after rotating it in the direction of the arrow in the figure.

9.
Release the lever (A), and then separate the canister close valve (B) from the fuel tank air filter (C) after rotating it in the direction of the arrow in the figure.

Inspection
1. Turn the ignition switch OFF. 2. Disconnect the CCV connector. 3. Measure resistance between the CCV termina ...

Installation
   • Install the component with the specified torques. • ...

See also:

Thermostat Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. Valv ...

Audio Remote Control Removal
1. Remove the driver airbag module. (Refer to Restraint - "Airbag module") 2. Remove the steering wheel front cover (A) after ...

Circuit Diagram
...

Copyright © www.ksmanual.com 2014-2023