1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the CCV connector.
|
3. |
Measure resistance between the CCV terminal 1 and 2.
|
4. |
Check that the resistance is within the specification.
|
5. |
Disconnect the vapor hose connected with the canister from the
CCV.
|
6. |
Connect a vacuum pump to the nipple.
|
7. |
Ground the CCV control line and apply battery voltage to the CCV
power supply line.
|
8. |
Apply vacuum and check the valve operation.
|
Input Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
Hill-start assist control (HAC)
A vehicle has the tendency to roll back on a steep hill when it starts to go
after stopping. The Hill-start Assist Control (HAC) prevents the vehicle from rolling
back by applying the brakes automat ...
Cooling Fan Removal and Installation
Cooling Fan Assembly
1.
Disconnect the battery terminals.
2.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust ...