1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the CVVT oil control valve connector (A).
|
3. |
Remove the installation bolt (B), and then remove the valve from
the engine.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
Yaw-rate and G Sensor Installation
1.
Remove the ignition key from the vehicle.
2.
Install inthe reverse order of removal.
3.
After installing the ...
Specifications
Purge Control Solenoid Valve (PCSV)
▷ Specification
Item
Specification
Coil Resistance (Ω)
19.0 ~ 22.0 [20°C(68°F)]
Fuel Tank Pre ...
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a know ...