Kia Optima Manuals

Kia Sorento: Rear Wheel Speed Sensor Removal - ESC(Electronic Stability Control) System - Brake System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Rear Wheel Speed Sensor Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor Removal

4WD only
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the rear wheel guard.
4.
Disconnect the rear wheel speed sensor connector (A).
5.
Installation is the reverse of removal.
  
Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1).
When inserting the sensor, take care the O-ring not to be damaged.
2WD only
1.
Remove the connector (A) after removing the front wheel speed sensor clip.
2.
Remove the rear wheel speed sensor.
(Refer to Driveshaft and Axle - "Rear Hub - Carrier")
3.
Installation is the reverse of removal.
Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Yaw-rate and G Sensor Description
The yaw rate and G sensor is included inside the air bag control module (SRSCM). When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate elec ...

See also:

Circuit Diagram
...

SRS Control Module (SRSCM) Removal
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

CVVT & Camshaft Removal
1. Remove the cylinder head cover. (Refer to Cylinder Head Assembly - "Cylinder Head Cover") 2. Set No.1 cylinder to TDC/comp ...

Categories

Copyright www.ksmanual.com 2014-2026