1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
|
3. |
Disconnect the connectors and cables (A) from center fascia panel.
|
4. |
Remove the heater control unit (A) with the rear glass defogger
switch.
|
Specification
Items
Inner side
Outer side
Front driveshaft
2.4GDI M/T
Joint type
LSJ 104
UBJ 104
Max. permissible angle
23В°
...
Photo Sensor Description
The photo sensor is located at the center of the defrost nozzles.
The photo sensor contains a photovoltaic (sensitive to sunlight) diode.
The solar radiation received by its light receiving ...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...