Kia Sorento: Rear Disc Brake Replacement
| 1. |
Remove the rear wheel & tire.
|
| 2. |
Loosen the guide rod bolt (B) and pivot the caliper (A) up out
of the way.
|
| 3. |
Replace pad shim (D), pad retainers (C) and brake pads (B) in
the caliper carrier (A).
|
| 4. |
Compress the piston into the caliper body using the SST (09581-11000).
|
| 5. |
Place the caliper body (A) on the caliper carrier and tighten
the guide rod bolt (B).
|
| 6. |
Install the rear wheel & tire.
|
Rear Disc Brake Removal
Rear Disc Brake InspectionBalance Shaft & Oil Pump Components
1. Balance shaft & oil pump assembly
2. Balance shaft chain tensioner
3. Balance shaft chain
4. Balance shaft chain sprocket
5. Balance shaft chain guide
6. Balance shaft ...
Master Cylinder Removal
1.
Turm ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Remove the air cleaner assembly.
G 2.4 GDI (Refer to ...
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [C300-A]
Pin
No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
[NON-smart ke ...