Kia Sorento: Rear Assist Arm Repair procedures

Removal

1.	Disconnect the (-) battery terminal.

2.	Remove the rear wheel and tire. (Refer to Tires/Wheels - "Wheel")

Remove the bolt (A), nut (B) and washer (C) to separate the rear assist arm (D) from the rear carrier.

Tightening torque :

156.9 - 176.5 N·m (16.0 - 18.0 kgf·m, 115.7 - 130.1 lb·ft)

Suspension System — Rear Suspension System / Rear Assist Arm / Repair procedures / Removal illustration

•	When removing the bolt, install the transmission jack and remove it under no load.

•	Mark the bolt, nut and washer in advance so that they do not change position and orientation.

Remove the bolt (A), nut (B) and washer (C) to separate the rear assist arm (D) from the rear cross member.

Tightening torque :

137.3 - 156.9 N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 lb·ft)

Suspension System — Rear Suspension System / Rear Assist Arm / Repair procedures / Removal illustration

Before removing the rear assist arm, mark the position and direction of the bolt and washer before changing.

Inspection

1.	Check the bushing for wear and deterioration.

2.	Check the rear assist arm for deformation.

3.	Check for all bolts and nuts.

Installation

1.	Install in the reverse order of removal.

2.	Check the alignment. (Refer to Suspension System - "Alignment")

Removal 1. Disconnect the (-) battery terminal. 2. Remove the rear wheel and tire. (Ref...

Removal 1. Disconnect the (-) battery terminal. 2. Remove the rear wheel and tire. (Ref...

Manuals list