Kia Sorento: PTG Spindle Removal
Kia Sorento (XM, 2011-2015) Service Manual / Body Electrical System / Power Tailgate Module / PTG Spindle Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the tailgate trim and Luggage side trim.
(Refer to the Body - "Tailgate")
|
| 3. |
Disconnect the power PTG spindle connector (A).
|
| 4. |
Using a screwdriver (A), lift up slightly the socket clips (B)
of both ends on the lifer (D), and then remove the PTG spindle from
the bracket (C).
|
| 5. |
If it is necessary, remove the nuts and replace the PTG spindle
bracket (A).
|
Anti-Pinch Strip Installation
1.
Install the tailgate anti-pinch strip.
2.
Install the tailgate side trim.
3.
Connect the negative (-) batter ...
PTG Spindle Installation
1.
Connect the PTG spindle, bracket and connector.
Tightening torque :
6.9 ~ 10.8N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0 lb-ft)
...
See also:
Windshield Wiper-Washer Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after loosening
3 screws.
...
Checking the tire inflation pressure
After driving briefly so as to distribute the sealant in the tire, check the inflation pressure.
After driving approximately 4–6 miles (7–10 km or about 10 minutes), stop ...
Installation
1.
Check that the shift lever is placed in the "N" position
2.
Install the inhibitor switch (A).
...
Copyright © www.ksmanual.com 2014-2026