Kia Sorento: Pressure Sensor Description

The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque value varies according to a pressure status.

Oil hydraulic Motor(Actuator) Installation

1. Before installation, wipe the surface with a clean cloth. 2. Check the O-rings (A) of the new hydraulic motor (actuators). ...

Pressure Sensor Circuit Diagram

...

See also:

General
1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is ...

Components
2WD 1. Rear upper arm 2. Rear stabilizer bar 3. Rear lower arm 4. Rear assist arm 5. Rear shock absorber 6. Rear cross member 7. Trailing arm ...

Antenna Removal
1. Remove the rear roof trim. (Refer to Body - "Roof trim") 2. Disconnect the power cable (A). 3. ...