1. |
Disconnect the negative battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front door")
|
3. |
Remve the screws(Inside:4EA, outside:1EA) from door module (A)
and connectors (B).
|
4. |
Remove the driver door module (A) from front door trim.
|
Cylinder Block Reassembly
1.
Install the oil jet (A).
Tightening torque :
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
...
Starter Relay Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay(A).
...
Alternator Inspection
[Rotor]
1.
Check that there is continuity between the slip rings (C).
2.
Check that there is no continuity between the slip ...