1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable from battery and wait for
at least thirty seconds before beginning work.
|
3. |
Place a passenger airbag on the crash pad and tighten the passenger
airbag mounting bolts.
|
4. |
Install the crash pad.
(Refer to Body - "Main crash pad assembly")
|
5. |
Tighten the passenger airbag mounting bolts.
|
6. |
Connect the passenger airbag harness connector to the SRS main
harness connector.
|
7. |
Reinstall the glove box housing.
(Refer to Body - "Glove box housing")
|
8. |
Reconnect the battery negative cable.
|
9. |
After installing the passenger airbag (PAB), confirm proper system
operation:
|
Special driving conditions
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extra ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the injector connector.
3.
Measure resistance between the inject ...
Heater & A/C Control Unit (DATC) Self Diagnosis
1.
Self-diagnosis process
2.
How to read self-diagnostic code
After the display panel blinks three times every 0.5 second, the
...