1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear bumper cover.
(Refer to Body - "Rear Bumper Cover")
|
3. |
Disconnect the connector (B) from the parking assist sensor (A).
|
4. |
Pull out the sensor (A) by opening the sensor holder (B) out.
|
Installation
•
Install the component with the specified torques.
•
...
Direct Electro Hydraulic Actuator Coupling Operation
Electronic Coupling
[Inactive]
[Active]
Operation Order
1.
4WD ECU receives CAN signals from the vehicle's sensors.
...
Transaxle Control Module (TCM) Installation
When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the ...