Kia Sorento: Oil Pressure Switch Inspection
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch Inspection
| 1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
|
| 2. |
Check the continuity between the terminal and the body when the fine
wire is pushed. If there is continuity even when the fine wire is pushed,
replace the switch.
|
| 3. |
If there is no continuity when a 50kPa (0.50kgf/cm², 7.25psi) is applied
through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm is broken. Replace
it.
|
Balance Shaft & Oil Pump Installation
BSM(Balance Shaft Module) Chain System
1.
The key of crankshaft should be aligned with the mating face of main
bearing cap. As a result of this, the piston of No.1 cylinde ...
Oil Level Gauge & Pipe Removal and Installation
1.
Remove the oil gauge(A).
2.
Remove the intake manofold.
(Refer to Intake And Exhaust System - "Intake Manifold")
...
See also:
Seat Belt Pretensioner (BPT) Description
The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH
& RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner
seat belt helps to reduce ...
Circuit Diagram
...
Shift Cable Components
1. Shift lever mounting bolt
2. Shift lever assembly
3. Shift cable assembly
4. Shift lever knob & boots assembly
5. Manual control lever
6. Retainer
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026