1. |
Turn ignition switch OFF.
|
2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Disconnect the solenoid valve connector (A).
|
4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
5. |
Check that the resistance is within the specification.
|
Room Lamp Removal
[General]
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver
t ...
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspec ...
Compass Mirror Function
1.
Push the A button lower of the rear view mirror to turn on the
function of the compass mirror so that displays a sign of a direction
on the small board in the upper ...